LED rechargeable flashlights usually use rechargeable batteries as the power source, so about the charging method of strong light flashlights, Tanke flashlight manufacturers will sort it out for you as follows

Check the flashlight model and manual: First, confirm whether the flashlight supports a built-in rechargeable battery, and check the manual to learn about charging methods and requirements.

Use the original charger: If the flashlight is equipped with a dedicated charger, please use the original charger for charging. Plug the charger into a power outlet.

Connect the charger: Locate the charging port on the flashlight, usually a round or rectangular jack. Connect the plug of the charger to the charging port of the flashlight.

Charging indicator light: Some flashlights have a charging indicator light that lights up when the flashlight is charging. According to the instruction manual of the flashlight, observe the status of the charging indicator to confirm whether the charging is normal.

Fully Charged: According to the instruction manual of the flashlight, it usually takes several hours to fully charge. Please wait patiently until charging is complete.

1. Matters needing attention:

Do not charge a non-rechargeable battery in a charger, as this may cause the battery to leak or be damaged.

Avoid charging in high temperature and humid environment to ensure safety and prolong battery life.

If the flashlight is not equipped with a dedicated charger, it can be charged with a universal USB charging cable and adapter. Make sure the adapter output voltage and current meet the requirements of the flashlight to avoid damage to the flashlight or batteries.

Self-defense strong light flashlight_led self-defense strong light flashlight

1. Unscrew the tail cap of the flashlight and take out the battery.
2. Put the battery into the special charging box (note: when putting the battery in, the positive and negative poles of the battery must be aligned with the positive and negative poles of the battery box, otherwise it will not be charged)
3. Take out the charger, insert the two pins into the power-taking interface, and insert the jack end into the battery box jack. When charging, the light on the charger is red. When the light turns from red to green, it means that the charging is complete. At this time, the battery can be taken out for use. How to use the strong light flashlight: 1. Battery installation Unscrew the tail cap, pay attention to the positive and negative poles of the battery, put the battery in, and screw on the tail cap. 2. Turn on the super bright flashlight. When it is off, press the rubber cap in the middle to turn on the flashlight. Repeat the above steps to turn it off. 3. Press the switch light to turn on the weak light when using the burst shot. If you need to switch the light, just click the switch to achieve tactical burst shooting. The functions are, in turn, low light, strong light, and flash. Press the switch light off. (use of tactical flashlight)