Though now, many LED flashlights are made of metal, for example stainless steel, aluminum alloy, etc., and are very durable, wearable, you also need to maintain them often. Since many new users do not know how to maintain flashlight, here, Tank007 editor will share you some tips about how to maintain led flashlight.

First, the battery

1. As the power source of the flashlight, battery is very important. You need to choose battery according to the flashlights specs, make sure not to use the battery with higher output current and voltage in case of ruining the circuit.

2. If you are using rechargeable flashlight, do not keep using the flashlight when the light changes dramatically, turn off the torch to prevent the battery from over discharge.

3. To avoid chemical corrosion caused by cause slurry leak, take out the battery from the flashlight if you do not use the flashlight for a long time.

4.Install the paper cover together with the battery to the flashlight, or it is easy to leak power. After a time, change the place of the new battery to extend the life of the battery.

Second, for the temperature

1, Heat dissipation: It is normal that the flashlight gets hot when it is on. So, do not forget to avoid the flashlight getting too hot. You are recommend not use the highest mode immediately after a full charge.

2, Many flashlights cannot work when it is minus 20 degrees, so keep warm if necessary.

3. Do not expose the flashlight under blazing sunshine for long when it is not in use; Do not repeat strobe.

Third, for the humidity

1. Moisture can ruin the flashlight. Keep the light cup dry and clean; do not wipe the cup with your hand or hard objects. To clean the finger print, you’d better use swap glass cleaner.

2. Wipe the water and sweat from the flashlight immediately, in case moisture getting in to the flashlight, corrupting the cladding.

Fourth, Special attention

1, Do not throw the light directly to people’s eyes, super bright light hurts eyes, especially the children’s in case of affect the vision.

2, When moving the flashlight’s switch, the strength should be equally, in order to maintain the flexibility of lift spring.

3. When using a flashlight, check the screws to see if any one is loosening; loosening screw may cause no light or dim light.

Now, do you know how to maintain LED flashlight? I think you do now. Leave your comment here if you have other questions.